Fits: Tesla Model 3 2017-2022
Enhance the look of your Tesla Model 3 with this beautiful spoiler wing. You will be getting compliments at the super charger every time you go!
This Rear Trunk Spoiler Wing is made of lightweight & top-grade durable ABS material. Protected with UV resistant glossy clear coating to prevent color fade. Glossy Carbon Fiber and stylish design. Enhances overall performance in handling and durability. This rear spoiler wing helps to add more downforce and helps the aerodynamic of your Tesla Model 3. Maintain the stability of the vehicle when at high speeds, reduce wind resistance, save fuel, enhance safety, make the driver feel more comfortable.
The spoiler can be a simple DIY installation. 3M tape is on the top and bottom of the inside of the wing for an easy peel and stick installation.
49 x 10.8 x 2 inch
1. Wipe the trunk install position with a towel and alcohol.
2. With the red tape still on, center the wing and mark both sides with masking tape to note the center.
3. Wipe the installation position with adhesion promoter (optional but recommended).
4. Tear off a piece of tape at both ends.
5. First fit the middle position of the rear wing to the vehicle and apply firm pressure for 1 minute.
6. Install both ends again, press, and fit on the two sides.
7. While pressing and fitting, tear off the adhesive paper.
8. Carefully tear off the adhesive tape at the lower end of the tail wing
9. Continue to press the rear wing hard, so that the rear wing is attached to the vehicle – there should be no gap
INSTALLATION TIPS (IMPORTANT):
1. When the temperature is lower than 50F, the adhesion becomes weak. In this case, it will be better to use a hairdryer to heat the double-sided tape.
2. You should wait 48 hours before washing the vehicle or letting water touch the area.